3D Printing: Difference between revisions
Content deleted Content added
Line 61:
For best results for most materials, apply a thin and even layer of gluestick (two passes, cross-hatched, 0% overlap). Gluestick acts as both an adhesive and release agent (for thick layers) and the amount required is material dependent. For PLA and similar plastics, use two passes--too much is not good. For CPE & PETG, apply 4 layers for better adhesion and release.
Certain high temp materials will stick strongly to glass and can crack it. For those, it's better to remove the prints before the glass cools fully to prevent this (ex: PC).
== Changing Nozzles ==
|