Fat Cat Fab Lab

CNC Router: Difference between revisions

Page Discussion

CNC Router (view source)

Revision as of 02:38, 8 June 2022

284 bytes removed ,  2 years ago
→‎The Cut
Line 234:
* tight radii causes the machine to adjust to a slower speed
* the part moves
 
Upcut vs Downcut vs Compression Bits: To be written...
* Downcut - good for veneers (like plywood)
* Upcut - good for chip evacuation
* Compression - Best of both worlds but the point where to two flute directions intersect should be at the middle or inside the depth of your stock.
 
Make sure to attach dust boot and turn on dust collector before cutting, or else use the shop vacuum tube without dust boot.
Retrieved from "https://wiki.fatcatfablab.org/wiki/Special:MobileDiff/871"