CNC Router: Difference between revisions
Content deleted Content added
No edit summary |
|||
| Line 280: | Line 280: | ||
* Press 'enter' then the command log will say it will now use the Measure Tool feature and to ensure it can move freely |
* Press 'enter' then the command log will say it will now use the Measure Tool feature and to ensure it can move freely |
||
:* This step will take into account the length of whichever tool used |
:* This step will take into account the length of whichever tool used |
||
* Press enter and the machine will move up to the |
* Press enter and the machine will move up to the Machine Z0 (the Z top hard limit), then move to the tool measure touch plate to measure the tool |
||
:* The machine knows the location of |
:* The machine knows the location of Machine Z0 and the Measure Tool operation allows the machine to figure out where the Z bottom limit is, relative to the machine Z0 |
||
* After the Measure Tool operation is completed, the Z bottom limit has been set |
* After the Measure Tool operation is completed, the Z bottom limit has been set |
||
* Test if the calibration has worked |
* Test if the calibration has worked |
||
:* Click the Park button to move the spindle to the |
:* Click the Park button to move the spindle to the Machine X0 Y0 Z0 |
||
::* This should be off the edge of the spoil board |
::* This should be off the edge of the spoil board |
||
:* Jog the bit downwards towards the bed |
:* Jog the bit downwards towards the bed |
||