CNC Router: Difference between revisions

Content added Content deleted

Inline

@@ Line 253: / Line 253: @@
 == Maintenance ==
 === Greasing Parts ===
 === Replacing the Spoilboard ===
 Threaded holes are 4" apart.
-=== Compressor/Air Tank Draining ===
+=== Surfacing the Spoilboard ===
-=== Replacing 3D Printed Clamps ===
-Print settings:
-* Position model on its side (bolt direction horizontal to bed)
-* 0.8 nozzle
-* 0.2 layer height
-* 10 walls
-* 50% infill, cubic subdivision
-* Generate support everywhere
-* Skirt
-== Troubleshooting ==
-=== Spindle wont start ===
-Hit reset button on spindle controller console. Check that speed control knob is fully clockwise.
-If there's an error code on the spindle's DRO, you can power cycle the machine (wait until the DRO LED's turn off). You WILL have to re-initialize and re-home your job though!
-=== WinCNC Wont Start ===
-Restart software.
-=== Z limit Error ===
 ''Only use this method if you are experiencing all the known issues below.''
@@ Line 310: / Line 291: @@
 :* Jog the bit downwards towards the bed
 ::* This should trip the Z bottom soft limit when the bottom of bit is just above the spoil board
+=== Compressor/Air Tank Draining ===
+=== Replacing 3D Printed Clamps ===
+Print settings:
+* Position model on its side (bolt direction horizontal to bed)
+* 0.8 nozzle
+* 0.2 layer height
+* 10 walls
+* 50% infill, cubic subdivision
+* Generate support everywhere
+* Skirt
+== Troubleshooting ==
+=== Spindle wont start ===
+Hit reset button on spindle controller console. Check that speed control knob is fully clockwise.
+If there's an error code on the spindle's DRO, you can power cycle the machine (wait until the DRO LED's turn off). You WILL have to re-initialize and re-home your job though!
+=== WinCNC Wont Start ===
+Restart software.
+=== Z limit Error ===
+Calibrate Switch was probably clicked on accident. See section Surfacing the Spoilboard for help.
 == Pinned Items from Slack #cnc and Other References ==