CNC Router: Difference between revisions
Content added Content deleted
Tag: Manual revert |
|||
Line 230: | Line 230: | ||
Typical feed rate ~200-300ipm. |
Typical feed rate ~200-300ipm. |
||
Calculate |
Calculate feed rate with this formula: |
||
(Feed rate) = (Chip load) x (Number of Flutes) x (Spindle Speed) |
|||
Match chipload with this formula: |
Match chipload with this formula: |
||
(Chip load) = |
(Chip load) = (Feed rate) / [(Number of Flutes) x (Spindle Speed)] |
||
Better to begin at lowest end of recommended |
Better to begin at lowest end of recommended feed rate and increase feed up to: |
||
* the finish deteriorates because of vibration of the cutting tool |
* the finish deteriorates because of vibration of the cutting tool |
||
* tight radii causes the machine to adjust to a slower speed |
* tight radii causes the machine to adjust to a slower speed |