CNC Router: Difference between revisions
Content added Content deleted
Tag: Manual revert |
|||
| Line 321: | Line 321: | ||
=== Replacing 3D Printed Dust Collection Boot === |
=== Replacing 3D Printed Dust Collection Boot === |
||
[[File:Dustboot1.jpg|thumb|alt=Dust boot|FCFL Dust Collection Boot]] |
[[File:Dustboot1.jpg|thumb|alt=Dust boot|FCFL Dust Collection Boot]] |
||
NOTE: This file's geometries tolerances need adjustment. It may work on some printers and not on others, so be prepared to modify as needed (either physically or digitally). |
|||
This part can be printed as one piece or as two separate pieces. |
This part can be printed as one piece or as two separate pieces. |
||
| Line 347: | Line 349: | ||
# Press in the magnets. The magnets should be about flush and in the same plane as the top surface of the boot. |
# Press in the magnets. The magnets should be about flush and in the same plane as the top surface of the boot. |
||
# Glue the magnets in place. |
# Glue the magnets in place. |
||
# Install the brushes. No glue is needed. |
# Install the brushes. No glue is needed. Will need to modify to fit. Clamp to press in bristles in place. |
||
# Drill holes to allow for M3 retaining "pins" to fit in. |
|||
== Troubleshooting == |
== Troubleshooting == |
||