749
edits
CNC Router: Difference between revisions
moved to 'z limit error' text to 'surfacing the spoilboard'
(moved to 'z limit error' text to 'surfacing the spoilboard') |
|||
Line 253:
== Maintenance ==
=== Greasing Parts ===
=== Replacing the Spoilboard ===
Threaded holes are 4" apart.
===
=== Replacing 3D Printed Clamps ===▼
Print settings: ▼
* Position model on its side (bolt direction horizontal to bed)▼
* 0.8 nozzle▼
* 0.2 layer height▼
* 10 walls▼
* 50% infill, cubic subdivision▼
* Generate support everywhere▼
* Skirt▼
== Troubleshooting ==▼
=== Spindle wont start ===▼
Hit reset button on spindle controller console. Check that speed control knob is fully clockwise. ▼
If there's an error code on the spindle's DRO, you can power cycle the machine (wait until the DRO LED's turn off). You WILL have to re-initialize and re-home your job though!▼
=== WinCNC Wont Start ===▼
Restart software.▼
=== Z limit Error ===▼
''Only use this method if you are experiencing all the known issues below.''
Line 310 ⟶ 291:
:* Jog the bit downwards towards the bed
::* This should trip the Z bottom soft limit when the bottom of bit is just above the spoil board
=== Compressor/Air Tank Draining ===
▲=== Replacing 3D Printed Clamps ===
▲Print settings:
▲* Position model on its side (bolt direction horizontal to bed)
▲* 0.8 nozzle
▲* 0.2 layer height
▲* 10 walls
▲* 50% infill, cubic subdivision
▲* Generate support everywhere
▲* Skirt
▲== Troubleshooting ==
▲=== Spindle wont start ===
▲Hit reset button on spindle controller console. Check that speed control knob is fully clockwise.
▲If there's an error code on the spindle's DRO, you can power cycle the machine (wait until the DRO LED's turn off). You WILL have to re-initialize and re-home your job though!
▲=== WinCNC Wont Start ===
▲Restart software.
▲=== Z limit Error ===
Calibrate Switch was probably clicked on accident. See section Surfacing the Spoilboard for help.
== Pinned Items from Slack #cnc and Other References ==
| |||