Fat Cat Fab Lab

CNC Router: Difference between revisions

Page Discussion

CNC Router (view source)

Revision as of 07:13, 30 April 2022

51 bytes added ,  2 years ago
→‎Pre-Check
Line 126:
[[File:Air Compressor Switch.jpg|thumb|alt=Air compressor toggle switch (red)|Air compressor toggle switch (red)]]
 
* Inspect the machine and bed for any debris, especially the ball screw
 
* Check that the hose in the compressor is attached to the CNC air -assist connection.
 
* Turn on the air compressor (push red toggle switch backward). Air-assist regulator should be at 90 PSI according to manual, but 40-45 PSI is fine for our machine.
 
* Adjust air compressor regulator to provide 60-80lbs80 PSI pressure to CNC (if it has itsbeen ownchanged. pressureThe CNC has a second regulator) regulator for the air-assist and should already be at 40-45 PSI since no one changes it.
 
* Turn on the Vacuum for dust collector
 
=== Warm Up Procedure ===
Retrieved from "https://wiki.fatcatfablab.org/wiki/Special:MobileDiff/810"