Laser Cutting: Difference between revisions
Content added Content deleted
Schuyler1d (talk | contribs) |
|||
| Line 350: | Line 350: | ||
=== Job Control error "No feedback from exhaust" === |
=== Job Control error "No feedback from exhaust" === |
||
* When you see this error message, it can help to reset the exhaust unit by holding down the "+" and "-" buttons simultaneously for 3+ seconds on the bottom front of the exhaust unit. |
* When you see this error message, it can help to reset the exhaust unit by holding down the "+" and "-" buttons simultaneously for 3+ seconds on the bottom front of the exhaust unit. |
||
=== Job Control error "No response from engraver" === |
|||
* Full error can be "Check if engraver is connected to the correct COM port and switched on" |
|||
* Obviously, make sure the Laser Cutter is on first and try again. If it is already on, check to see if there are TWO tasks (in task manager/bottom Windows task dock) for the Job Control program. If there are, quit/close one and try again. |
|||
=== Laser decides not to cut all, or certain vectors === |
=== Laser decides not to cut all, or certain vectors === |
||