Laser Cutting: Difference between revisions
→Job Control error "No response from engraver"
Schuyler1d (talk | contribs) |
|||
Line 350:
=== Job Control error "No feedback from exhaust" ===
* When you see this error message, it can help to reset the exhaust unit by holding down the "+" and "-" buttons simultaneously for 3+ seconds on the bottom front of the exhaust unit.
=== Job Control error "No response from engraver" ===
* Full error can be "Check if engraver is connected to the correct COM port and switched on"
* Obviously, make sure the Laser Cutter is on first and try again. If it is already on, check to see if there are TWO tasks (in task manager/bottom Windows task dock) for the Job Control program. If there are, quit/close one and try again.
=== Laser decides not to cut all, or certain vectors ===
| |||