Welding Checklist: Difference between revisions
Content deleted Content added
Created page with "= Start up: = * ☐ Material cleaned and tungsten prepped * ☐ Shielding gas turned on (turn main tank valve counter-clockwise to open) * ☐ Regulator tank pressure (right gauge) and regulator output pressure (left gauge) is above zero - notify instructor when low * ☐ Machine plugged into 20A source, turned on (switch in back) * ☐ Fume exhaust turned on * ☐ Ground clamp secured to worktable or work * ☐ Proper attire, gloves, helmet adjusted = Shut down: = *..." |
No edit summary |
||
(2 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
= Start up: = |
== Start up: == |
||
⚫ | |||
* ☐ Material cleaned and tungsten prepped |
|||
* Photo regulator tank volume (right), check output pressure (left) is set 7-12 |
|||
⚫ | |||
⚫ | |||
* ☐ Regulator tank pressure (right gauge) and regulator output pressure (left gauge) is above zero - notify instructor when low |
|||
* Torch: check tungsten & hang securely on table |
|||
* ☐ Machine plugged into 20A source, turned on (switch in back) |
|||
* Pedal: set on floor |
|||
* ☐ Fume exhaust turned on |
|||
* Fume extractor: position over work & turn on |
|||
⚫ | |||
* |
* Proper attire: Adjust helmet, wear gloves |
||
* Machine: turn on |
|||
= Shut down: = |
== Shut down: == |
||
* Machine: turn off |
|||
* |
* Hot work: put in a safe place to cool |
||
* ☐ Machine off |
|||
* Torch: remove tungsten and sharpen |
|||
⚫ | |||
* Torch: clean ceramic cup, reinstall tungsten |
|||
* ☐ Clean work area |
|||
* Pedal, torch, & ground clamp: coil neatly and hang |
|||
* ☐ Fume exhaust off |
|||
⚫ | |||
* ☐ Sharpen tungsten for next person |
|||
* Photo regulator tank volume (right) |
|||
* ☐ Clean electrode holder, install tungsten, coil cables, stow foot pedal |
|||
* Fume extractor: turn off |
|||
⚫ | |||
* Clean work area: clamps away, sweep tables and floor |
|||
⚫ |
Latest revision as of 23:42, 30 October 2023
Start up:
- Shielding gas: open main valve (turn counter-clockwise)
- Photo regulator tank volume (right), check output pressure (left) is set 7-12
- Ground clamp: secure to worktable or work
- Torch: check tungsten & hang securely on table
- Pedal: set on floor
- Fume extractor: position over work & turn on
- Proper attire: Adjust helmet, wear gloves
- Machine: turn on
Shut down:
- Machine: turn off
- Hot work: put in a safe place to cool
- Torch: remove tungsten and sharpen
- Torch: clean ceramic cup, reinstall tungsten
- Pedal, torch, & ground clamp: coil neatly and hang
- Shielding gas: close main valve (turn clockwise), leave regulator as is
- Photo regulator tank volume (right)
- Fume extractor: turn off
- Clean work area: clamps away, sweep tables and floor
- Return in 20 minutes for fire safety check